|
8ft mono pair Retail $3,599 CDN
10ft
mono pair Retail $3,839 CDN
8ft bi-wire pair Retail $4,559 CDN
10ft
bi-wire pair Retail $4,799 CDN
8ft bi-cable pair Retail $5,519 CDN
10ft
bi-cable pair Retail $5,879 CDN
WBT-0680 Cu Spade or WBT-0645 Banana
|
|
The faint voices you sometimes hear
during a phone conversation are an example of signal interference between
adjacent or nearby conductors, commonly known as CROSSTALK. The term is also
applied to frequencies above the audio range where more serious consequences
occur when inductive or capacitive crosstalk creates distorted or erroneous
data in data link systems.
The measurement of crosstalk consists of sending a signal of known strength
through a conductor and measuring the effect of this signal in an adjacent or
nearby conductor. Typically, the crosstalk is measured at the same end of the
cable that the signal is sent from. This is known as NEAR END crosstalk
(NEXT). Expressed in decibels (dB),
a higher number is better. NEXT is affected by signal frequency, cable
construction, and installation / connection.
The ability to maintain a high NEXT is the design foundation of our Chime
speaker cable. In order to minimize
crosstalk and keeping a high NEXT number, our Chime speaker cables physically
separate the positive and negative signal to eliminate crosstalk between
conductors.
To control the unwanted resonance, we have incorporated the use of aluminum (like the rest of the Chime series) to further
dampen the resonance besides the material we are using at the end of the
cables. The dimension of the cuboid is designed according to the golden-ratio. Aircraft-grade aluminum
is used to absorb any vibrations from the cable. By sliding the cuboid into a different position, it will change the
resonance of the cable thus yielding a different sound for fine-tuning.
Chime speaker
cables give you an articulate and authoritative bass that brings out the
lower-level detail of the recording. Our speaker cables are also capable of
delivering very rich mid-range harmonics and extremely smooth highs. Since
the crosstalk is kept at a minimum, you would be able to hear details and
resolution that you had never heard before. The separation between
instruments will become more pronounced; the focus will become clearer and
much tighter.
Specifications
for Chime2 Single-Wire Speaker Cable:
- Cable Diameter: 1.5"
- Conductor Diameter: .282"
- Conductors: Multi-Stranded High
Purity Oxygen Free Copper
- Discrete Conductors: 818
- Insulation: Low dielectric DuPont
TEFLON PFA
- Shielding: 100% Copper Braided
Shielding
- Connector: WBT-0680 Cu Sandwich
Spade or WBT-0645 Banana Plug
|
